Xiaomi Pad 6 TWRP Flashing Guide

Prerequisites

• A Windows PC with ADB and Fastboot installed
• Download TWRP for Pad 6
• Stock boot image (from your device's official firmware page)
• USB cable, OTG adapter.
• Backup your data and ensure the tablet is charged to at least 60%

Additional Notes

• TWRP is made by rmux.
• Ofox n PBRP is WIP (after I fix my shit grades).

1. Booting TWRP via Fastboot

1. Power off your device and boot into Fastboot mode (usually by holding Volume Down + Power).
2. Connect your device to your PC via USB.
3. Open a command prompt and run:

   fastboot boot twrp.img

   This temporarily boots your device into TWRP recovery.

2. Installing TWRP Permanently

1. Boot into TWRP (if not already there).
2. Navigate to Advanced in TWRP.
3. Select Install Current TWRP and tap Install to confirm.
4. Reboot by selecting Reboot > Reboot to Recovery. TWRP is now permanently installed on your device.

3. Flashing a Kernel Using TWRP

1. From the TWRP main menu, tap Install.
2. Browse and select your kernel ZIP file.
3. Swipe to confirm the flash and wait for the process to finish.

4. Flashing a Custom or Stock ROM via USB Drive

1. Prepare the USB Drive:
   • Copy your rom.zip file (custom or stock) onto the USB drive.
   • Connect the USB drive to your device using an OTG cable.
2. Format Data Partition:
   • In TWRP, go to Wipe.
   • Select Format Data and type yes to confirm the wipe for a clean installation environment.
3. Install the ROM:
   • Return to the TWRP main menu and tap Install.
   • Browse to your USB drive, select the rom.zip file, and swipe to confirm the installation.
   • Wait until the flashing process completes.
4. Reboot:
   • Once flashing is complete, select Reboot to restart your device normally.